© 2024 R-Tools Technology Inc.
All rights reserved.
This chapter explains how to perform data recovery operations over network.
R‑Studio for Linux has network capabilities that allow the system administrator, using its computer, to recover files on any computers accessible over network.
R‑Studio for Linux supports the TCP/IP protocol and any protocol supported in Microsoft Network.
R‑Studio Agent must be installed on computers where files are to be recovered. This program gives R‑Studio for Linux access to local disks on remote computers over network.
If, due to file system crash, the network computer where you are going to recover your data cannot start, you may use R‑Studio Agent Emergency to start the computer.
Files can be recovered without R‑Studio Agent if the computer where the files are to be recovered runs Windows NT/2000/XP/2003/Vista/2008/7/8/8.1/10 is accessible from a computer also running Windows NT/2000/XP/2003/Vista/2008/7/8/8.1/10. In this case, the administrator must have administrator privileges on the remote computer.
You should always disable a firewall and/or antivirus software on the both computers. As an alternative, advanced users may tune them to allow R‑Studio for Linux and R‑Studio Agent to communicate via network.
All data transmitted over network are encrypted with a strong algorithm for data security. Restoring data over network is very much the same as that on a local computer.
In addition, R‑Studio for Linux can load/save any files like disk images , scan info files, RAID configuration files, from/to the computers to which it has access using R‑Studio Agent .